Jump to content


Henchmen4Hire

Member Since 08 Sep 2012
Offline Last Active Jun 17 2017 09:35 PM

Topics I've Started

M-44 Hammerhead [Finished!]

24 June 2013 - 04:28 AM

EDIT: Model is now final

 

More pics/notes on the Flickr page.

 

9146355967_e575faed09_o.png
M-44 Hammerhead by Henchmen4Hire, on Flickr


M-35 Mako [Mass Effect]

17 June 2013 - 11:39 PM

EDIT: Here's the final final final updated LXF file lol

 

http://www.mediafire...uyyvv5/MAKO.LXF

 

•Seats 3-4 figures

•Hatches on the sides open

•Working suspension (rubber bands)

•Cannon rotates and tilts up and down

•Mostly accurate

•Mostly sturdy lol

 

 

13944514584_759b0d1305.jpg

M-35 Mako [Mass Effect] by Henchmen4Hire, on Flickr

 

 

 

13944514344_3f233f7b7a.jpg

M-35 Mako [Mass Effect] by Henchmen4Hire, on Flickr

 

YVKNTtX.jpg

 

8j6rn3H.jpg

 

T6LVtsX.jpg

 

Mvq4OOp.jpg


Curved Female Torso

28 May 2013 - 04:32 AM

I wanted to see how a female LEGO minifigure would look with more of an hourglass torso so I did a little dremeling and sanding.

I like this result a lot more than Arealight's curved torsos, the difference being that my curve runs from under the armpit to the waist while Arealight's is a lot shorter.

I did this all freehand and it looks pretty good. The chest design is cut into a bit because it was slightly off-center to begin with.

I'll probably add this curviness to my upcoming Samus Aran custom Minifig.

8863068162_b4d5827d29_o.png
LEGO Curved Female Torso by Henchmen4Hire, on Flickr

8863067652_b7077b2033_o.png
LEGO Curved Female Torso by Henchmen4Hire, on Flickr

8862458487_bf99b6307e_o.jpg
LEGO Curved Female Torso by Henchmen4Hire, on Flickr

 


Samus Aran (Metroid)

27 May 2013 - 07:24 PM

Ordered a set of decals and one of them was Samus. Not happy with just adding a sticker, here are some ideas for making the figure even cooler.

This is a straight-up LDD build with photoshopped decals. I like it because it's simple and effective. I'd have to paint the robot arm orange and helmet red.


dfhfs_zps877ed6f2.png

And I might get crazy and go further! I already cut a trans-neon-green visor to fit roughly into the GP's visor area, as shown here. Next step would be to cut the chest armor so only the red area remains, that way the chest protrudes. Probably attach some orange 1x1 round plates to the shoulders with tape so they're flexible. Then I'd cut the red part out of the sticker and stick that to the armor. I'll have to get another whole chest piece sticker to put on the torso.

I really like this one, it has some much needed added height too.

samusdgsf_zps5bc01c99.png

Also, I may just splice the bottom part of some orange legs to the yellow uppers because I don't feel like painting, the stickers would cover the seam anyway.

Thoughts?